Product description
To install Ancor twist-on connectors, strip the cable to expose 9/16" of the center conductor. Strip the outer jacket to expose 1/4" of the braid. Make sure that the braided shield does not touch the inner conductor. Insert the cable into the connector until the center conductor protrudes through the center of the connector. Twist the small knurled end while gently pushing the connector onto the cable until resistance is felt. Crimp the center conductor. Cut off any excess. It is strongly recommended that a piece of Ancor 3/4" heat shrink be installed on all exterior UHF connectors to waterproof and relieve strain.
Reviews
Recently Viewed
Ancor Marine
Male Plug RG58 Coax Wire Twist On
C$10.99
Ancor Marine
Ring Connector 12-10 3/8 Heat Shrink | 3/pkg
C$6.75
3M Products
3M 4000 UV Marine Sealant Cartridge White
C$32.95
Ancor Marine
Disconnect Insulated 12-10 Nylon Female | 3/pkg
C$4.80
Harken
Harken 40 Winch Jaw Assembly
C$53.50